#1 working on the 3/4 rear door and the skins

Today, I've worked on the skins with the 3/4 rear door. I've put the front inner skin and the rear inner skin on the frame maintained with 2 straps (the 2 center vents are not at the good place but it's not a problem for now)



The front skin is correctly positioned with the com-8A and the built-in large data port, there's no adjustment needed, the LDP put the skin at the good place without ambiguity.
I think that the rear skin has been well positioned; the front and rear skins looks good and there's no gap between the 2 skins on the right and left side
then I've drawn a line round the rear door from the inside with a felt-tip pen and the skins on. the idea is to show where i will have to cut the inner door.
I've noticed that the rear door is not in the middle of the skins and before cutting, I prefer ask the r2builders if it's correct or if i've made something wrong